Save time, sensors, and wiring with Classic Instruments' Zeus-Link all -inclusive gauge interface modules. They will read vehicle data from CAN BUS to drive any Classic Instruments gauges accurately. These units are offered in several styles for connection to a GM OBDII port, Holley Sniper ECU and other Holley ECUs, or a Holley Sniper II ECU. Choose the correct module for your application.

Additional features of Zeus-Link modules:

* System queries vehicle upon installation to determine what list of parameters can be obtained from the vehicle and used as inputs to gauges
* Spaces for six standard gauges: speedometer, tachometer, fuel, oil, volt, temperature, and two auxiliary gauges of the customer's choosing
* All instruments can be driven traditionally through proper senders if vehicle ECU does not support an output the driver wants to monitor
* Set up and managed all through an app available on the App Store or Google Play
* The app is used to configure by choosing which gauges a customer has in the dash and how each gauge gets its signal
* The app has a virtual gauge screen, aligning with the dash instruments
* The app has easy diagnostics, displays values being received by Zeus-Link and will allow user to cycle gauges to predetermined positions, to verify and correct outputs and wiring
* Warning and check engine light outputs on the Zeus-Link and external contacts to light a dash light
* Dash light connection
* All gauge connections to Zeus-Link (power, ground, signal, dash lights)
* Additional resistor dongle available if needed to use multiple Holley CAN devices on the same harness
* Harness plugs direct into Zeus-Link and then to Holley ECU or OBD
* Holley harness has additional Holley ECU connector for other devices
* On-board diagnostic lights give status of power, BLE, and data on the circuit board for Zeus-Link
* Pass-through CAN port connection for other CAN devices
* Compatible with all Classic Instruments sending units and gauges